I've been making keycaps with UV resin. Gonna try my luck with epoxy resin next! : r/ResinCasting
Would this be a good UV lamp if not what UV lamp should i get : r/3Dprinting
Using this type of lamp (60w) to cure UV resin, but it still ends up tacky. What could be the problem? : r/ResinCasting
My $16 resin print curing “station” : r/3Dprinting
Best UV flashlight 🔦 for Minerals/specimens. Lumenshooter S5 vs UVBeast V3 365nm : r/flashlight
Why spend hundreds on a UV cure chamber when a couple RGB pucks and a $20 motorized turntable will do! I still want one though... : r/3Dprinting
My compact solution for resin printing in my home office. Thanks to this subreddit for the grow tent idea! Keeps the fumes trapped within and UV out. My asthma thanks you too.
UV vs. white light for post curing? : r/resinprinting
Help UV Flashlight owners fight this patent troll! : r/flashlight
16 pin uv lights for curing the inside of my models!! Works wonders, cost $15 bucks : r/resinprinting
My prototype resin curing boxing : r/resinprinting
HELP! I bought this UV lamp for resin curing. But I realize that 60 sec is not enough to fully cure my UV resin (it's still sticky on the surface). Since I
I have one aquarium uv light lying around, can the resin be cured under this setup? : r/AnycubicPhoton
Got a resin printer recently and and looking for a UV light to cure the prints, would either of these be fine? : r/resinprinting
Glazing little dudes with UV resin, coming out tacky. 72W dome, tried multiple brands, left in for over 20 minutes. Help? : r/polymerclay
Rate my set up, UV curing station. Question: how far away should lights be? : r/resin
Would this UV light work to cure resin prints? : r/3Dprinting
Dental resin curing lamp : r/resinprinting
Using a hand held UV torch to detect and cure small resin spills on nitrile gloves, paper towels etc? : r/resinprinting
UV LED strip for DIY Curing Chamber : r/resinprinting
Rate my set up, UV curing station. Question: how far away should lights be? : r/resin
UV light (help) : r/3Dprinting
So I also decided to cure my workstation to solidify any escaped resin. Thought the cover on the printer would block out the UV-light. Turns out it didn't. : r/resinprinting
Got a resin printer recently and and looking for a UV light to cure the prints, would either of these be fine? : r/resinprinting
